Configure your puriFlash^® 5.020-5X

Optimized for Ultra Performance Flash Purification

Basic configuration

• Components
  •  Control unit
  •  Pump
  •  UV detector
  •  Fraction collector
  •  Solvent container
  •  5 integrated column supports
  •  Accessories set
• .
• Pump
  •  Flow rate : 300 ml/min
  •  Optimum flow rate for columns up to 90 mm internal diameter
  •  Max. pressure: 20 bar
  •  Quaternary gradient valve
  •  Air vent
  •  Solvent heater (under development)
  •  Retention tank with leak detector
• .
• Injection
  •  Injection mode: liquid or solid
  •  “Load & Go” technology: with automatic 6-way valve which allows the use of an injection loop for an even more efficient injection
  •  RFID technology : automatic detection of the injection loop
  •  Injection loop 2 ml of stainless steel
  •  Retention tank with leak detector
• .
• Detection
  •  UV detector 200-400 nm
  •  “DAD“ technology
  •  Multi-wavelength and scan over a band of 200 nm (or 600 nm with the UV extended pack)
  •  Spectral visualization and confirmation of purity
  •  0.3 mm optical path cell
  •  Retention tank with leak detector
• .
• Column and support compatibility
  •  Normal phase(NP)
    Particle sizes: 15 µm, 25 µm, 30 µm, 50 µm
  •  Reverse phase (RP)
    Particle sizes: 30 µm, 50 µm
  •  Format: all Flash columns up to an internal diameter of 90 mm are compatible
  •  5 integrated column supports
  •  RFID technology: automatic detection of the columns during insertion
• .
• Fraction collector
  •  Capacity:
    – 3 racks
    – 132 tubes (18 x 150 mm)
  •  Technology:
    – Drainage system for the fraction collector
    – Automatic cleaning of the fraction collector needle (to avoid cross-contamination with the previous purification)
    – RFID technology: automatic detection of the racks on the collector
• .
• Proposed racks
  •  Delivery includes 3 selected racks from the list below:
    – Rack for tubes:
    13 x 73 mm | 13 x 100 mm | 16 x 150 mm
    18 x 150 mm | 21 x 150 mm | 25 x 150 mm
    28 x 150 mm | 29.5 x 200 mm
    – Rack for Schott laboratory bottles 250 ml
    – Rack for funnels
    Position of the numbered tubes (to facilitate identification of tubes)
• .
• Software & control unit
  •  Control via InterSoft X software
  •  Remote control
  •  Touchscreen 15“
  •  8 USB ports
  •  “Flash & Go“ technology: compatible with our smartphone app TLC to Flash & Prep
• .
• System optimization
  •  Tubes with 1.6 mm internal diameter
  •  Optical path length detection cell: 0.3 mm / 40 μl
• .
• Safety
  •  Level detectors for solvents
  •  Retention tank for solvents on the pump, valve and detectors (with leak detector)
  •  Collector with drainage system, equipped with a leak detector
  •  “Fume Encloser“ technology (allows use of the purification system without the extractor hood)
• .
• Communication
  •  Network cable RJ45
  •  Communication cable Sub-D9 male/female
  •  Communication cable Sub-D9 female/female